⏣ General Metalworking

30778 Threads Posts
to

end mill - question why the thread?

G'day, I bought an end mill the other day and it came with a thread on the end.. I was under the impression that endmil...
5 comments posted 22yrs
posted by des.bromilow
5 comments posted 22yrs posted by des.bromilow

Cutting lubricant for unheated shop (NY)

Any recommendations for a lubricant to use in an unheated shop? Do the water based lubricants freeze or become too visco...
7 comments posted 22yrs
posted by walter_munney
7 comments posted 22yrs posted by walter_munney

A little OT: Towing advice

I may end up having to move a dead dually pickup from PA to Michigan and I'm trying to figure out the best cost/safety...
8 comments posted 22yrs
posted by paul
8 comments posted 22yrs posted by paul

Return of Tin Foil Beanie Guy

Now exactly who was that gent who became so famous on this ng, was it Mr. Ryker? Anyway I thought you folks would appre...
3 comments posted 22yrs
posted by jim_member
3 comments posted 22yrs posted by jim_member

bonding steel to slate?

I obtained a free piece of slate, about 2.75' x 4.5' x 1" thick from my local pool table dealer (the slates come in mat...
10 comments posted 22yrs
posted by rick
10 comments posted 22yrs posted by rick

?Threshold pressure for supersonic gas escaping?

When an engine without a muffler or a rifle makes noise when the gas escapes from behind the exhaust value or from behi...
22 comments posted 22yrs
posted by c.magnuson
22 comments posted 22yrs posted by c.magnuson

8" Chuck CNC Lathe on eBay $1 N/R

http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=12577&item=2590196986 IKEGAI FX-20N Fanuc 6T CNC 8" Chuck Runs r...
1 comments posted 22yrs
posted by steve
1 comments posted 22yrs posted by steve

Vacuum Pump Oil

So I was browsing around in a new farm/tractor store yesterday to see what their inventory was like, and I saw some vac...
20 comments posted 22yrs
posted by kwag98
20 comments posted 22yrs posted by kwag98

tiller head part/making do

Ideas needed for converting an Ariens ST524 to a garden tiller. The part used to do this is now obsolete...Ariens part...
5 comments posted 22yrs
posted by tallgrassprairie
5 comments posted 22yrs posted by tallgrassprairie

Spot Welder homebrew? Soldering gun?

An old PM article uses a homebrew transformer similar to the one I wound in 10th grade for my from-scratch soldering gu...
15 comments posted 22yrs
posted by markotime
15 comments posted 22yrs posted by markotime

Shores "Hercules" Engine

Has anyone out there built this engine? I could use some help with turning the camshaft. Thanks in advance. Steve M
1 comments posted 22yrs
posted by smulholl
1 comments posted 22yrs posted by smulholl

Long-lasting Dremel cutting wheel

A few months ago someone mentioned that there are Dremel cutting wheels that don't break so easily.
4 comments posted 22yrs
posted by tdnews01
4 comments posted 22yrs posted by tdnews01

HELP! Rust on collets

Hi all, Well this weekend I got back from cabin fever all fired up and went to the basement to look all through my Myfo...
13 comments posted 22yrs
posted by pjpickard
13 comments posted 22yrs posted by pjpickard