⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30777 Threads Posts
to

Worth reading in ⏣ General Metalworking

Installing aftercooler on a compressor?

On this trailered compressor that I am demolishing, there is an aftercooler. You can see it in front of a radiator here...
2 comments posted 15yrs
posted by ignoramus3845
2 comments posted 15yrs posted by ignoramus3845

what to do with old lawn mower blades?

Gardening for guys Is time to go get new lawn mower blade. It isn't just that this one is flat on the leading edge, but...
6 comments posted 15yrs
posted by phamp
6 comments posted 15yrs posted by phamp

12v hydraulic pumps

Three 12v hydraulic pumps followed me home. They are gently used or new old stock, but similar to these: http://goo.gl/...
16 comments posted 15yrs
posted by ignoramus2853
16 comments posted 15yrs posted by ignoramus2853

Tom Gardner - Why 750 Hours?

Not sure if you saw my questions in that other thread, so here it is again, > >> Ok... I know some are going to say its...
3 comments posted 15yrs
posted by none
3 comments posted 15yrs posted by none

!!! HAPPY CANADA DAY !!!

Looks like a beautiful day to celebrate, so !!!! HAPPY CANADA DAY !!!!!! to everyone. Brian and Frances Lawson, Bothwell...
4 comments posted 15yrs
posted by lawsonb
4 comments posted 15yrs posted by lawsonb

Angle iron

I needed some 3/4"x3/4"x1/8" angle iron for a project. Previously I bought a 3-foot length in Home Depot so I headed ba...
24 comments posted 15yrs
posted by mkoblic
24 comments posted 15yrs posted by mkoblic

What is this tool

http://igor.chudov.com/misc/ebay/tmp/premier/IMG_6735.JPG
9 comments posted 15yrs
posted by ignoramus18155
9 comments posted 15yrs posted by ignoramus18155

480 wiring convention

I've got three 480 volt plasma cutters my son is going to test at work. He asked me to get them all strapped to a palle...
14 comments posted 15yrs
posted by karltownsend.NOT
14 comments posted 15yrs posted by karltownsend.NOT

What is it? Set 395

I need some help figuring out the third item in this set: http://55tools.blogspot.com/ Rob
37 comments posted 15yrs
posted by rhvp65
37 comments posted 15yrs posted by rhvp65

Fraudulent work at home scam

(as opposed to an honest work at home scam?) Here's a good one. URL has an extra space to not promote it too much. http...
12 comments posted 15yrs
posted by ignoramus20088
12 comments posted 15yrs posted by ignoramus20088

Endmill regrinding

Just dropped off about 30 lbs of end mills to be reground. I have never done it before. The regrinding shop has an awes...
28 comments posted 15yrs
posted by ignoramus20088
28 comments posted 15yrs posted by ignoramus20088

[Quite OT:] Roaches!

Over the last couple months, I've captured a total of three cockroaches whilst they were on patrol in my garage. (Just...
7 comments posted 15yrs
posted by Winston
7 comments posted 15yrs posted by Winston

Bearings

Ok... I know some are going to say its just the wrong tool for the job, but I get a lot of use out of the little Bosch...
5 comments posted 15yrs
posted by none
5 comments posted 15yrs posted by none