⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30748 Threads Posts
to

Traveling Hydraulic Press

I sometimes have to press premade registers and pins into molds that are rather to large to hold flat easily on the arb...
10 comments posted 4yrs
posted by none
10 comments posted 4yrs posted by none

Adhering other metal molts to sheet iron

Hi there, I'm trying to find if I can drop molten metals onto metal sheet, I'm thinking aluminum or copper on to an iron...
14 comments posted 4yrs
posted by 0f8503901d844703eea1acecb7a4938a_2780
14 comments posted 4yrs posted by 0f8503901d844703eea1acecb7a4938a_2780

Adhering other metal molts to sheet iron

Hi there, I'm trying to find if I can drop molten metals onto metal sheet, I'm thinking aluminum or copper on to an iron...
15 comments posted 4yrs
posted by Colin
15 comments posted 4yrs posted by Colin

origin of odd decimal shaft sizes

Where do shaft sizes like 0.1545" come from? There's a few small diameter ones like this that don't match any fraction I...
13 comments posted 4yrs
posted by presence
13 comments posted 4yrs posted by presence

Toilet designed to fail ?

Have any of you ever seen a toilet that seemed like it was designed to fail ? And it had reduced weight requirements whe...
0 comments posted 4yrs
posted by mogulah
0 comments posted 4yrs posted by mogulah

Thread Milling

Note: All of the below is in relation to aluminum. Mostly 6061, some 7075, MIC6, ATP-5, and rarely 5052. (All CNC) On t...
2 comments posted 4yrs
posted by none
2 comments posted 4yrs posted by none

Cable TV Internet Service Problem -- Solved

Recently, I have been bedeviled by unstable Internet service from COMCAST (Xfinity) in the Boston area. The following s...
20 comments posted 4yrs
posted by joegwinn
20 comments posted 4yrs posted by joegwinn

wrenching

Finally got my Ranger (1996) out of "the hospital" after an 11 day stay. It was pretending to be either British or a Ha...
2 comments posted 4yrs
posted by clare
2 comments posted 4yrs posted by clare

OT cooling system leakdown rate

Does anybody know a "rule of thumb" for realistic cooling system leak rates on 300-ish CI v8 engines? Tested with compr...
2 comments posted 4yrs
posted by bp
2 comments posted 4yrs posted by bp

Power Feed Blowup , the Sequel

I just got finished a little bit ago replacing the shorted diodes , and the PF is working just fine again . Cause of th...
9 comments posted 4yrs
posted by Snag_one
9 comments posted 4yrs posted by Snag_one

Tormek vs. WS3000 vs. 1x30 belt sander

As sharpening systems go how do these three compare? I am really confused. I see that the water-cooled Tormek is really...
11 comments posted 4yrs
posted by galt_57
11 comments posted 4yrs posted by galt_57

Handle model # HCW-135G

Handle for a WellSetting power feed
0 comments posted 4yrs
posted by 0f8503901d844703eea1acecb7a4938a_2773
0 comments posted 4yrs posted by 0f8503901d844703eea1acecb7a4938a_2773