⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30775 Threads Posts
to

Worth reading in ⏣ General Metalworking

Monarch series 61 lathe (2025 Update)

https://www.govdeals.com/index.cfm?fa=Main.Item&itemID=1376&acctID=7396 I'm not affiliated with the auction outfit in a...
0 comments posted 7yrs
posted by lbfulton
0 comments posted 7yrs posted by lbfulton

Stacked set screws? (2025 Update)

My home made sawmill uses L095 Lovejoy couplers to connect the engine to the transmission, and their set screws loosen...
7 comments posted 7yrs
posted by muratlanne
7 comments posted 7yrs posted by muratlanne

Self Centering Vise - Cheap (2025 Update)

I asked about this sometime back and I seem to recall the cheap ones like this were not reported to repeat all that wel...
0 comments posted 7yrs
posted by none
0 comments posted 7yrs posted by none

Ping Ed Huntress (2025 Update)

I have not been here in a LONG time. Sorry, just to much political BS for me. I am looking for Ed Huntress. Still around...
0 comments posted 7yrs
posted by karltownsend
0 comments posted 7yrs posted by karltownsend

Tompson Table (2025 Update)

I am considering making something like a Thompson table, but smaller, For use on a drill press or a Drill mill, And won...
0 comments posted 7yrs
posted by dcaster
0 comments posted 7yrs posted by dcaster

DuMore 21-011 drill sharpener (2025 Update)

If anyone is interested in a DuMore drill sharpner at considerably less than the one listed on Ebay please contact me....
0 comments posted 7yrs
posted by email
0 comments posted 7yrs posted by email

Home Made Floating Reamer Holder (2025 Update)

I've found that for small chucking reamers they tend to flex enough that any tiny misalignment doesn't matter, but for...
1 comments posted 7yrs
posted by none
1 comments posted 7yrs posted by none

O-1 vs W-1 (2025 Update)

One of my guilty pleasures is watching "Forged in Fire." While I wish they'd put a lot less energy into attempting to c...
5 comments posted 7yrs
posted by rangerssuck
5 comments posted 7yrs posted by rangerssuck

My Spindle Isn't Worn Out (2025 Update)

My Spindle Isn't Worn Out Collets are Consumable For the last month or so I started noticing alignment pin holes that a...
0 comments posted 7yrs
posted by none
0 comments posted 7yrs posted by none

Diversity Help By Sanctuary City/States

City Says It Will Welcome Immigrants Amid Proposal Regarding Sanctuary Cities ABC Local - April 15, 2019 --...
0 comments posted 7yrs
posted by bruce2bowser
0 comments posted 7yrs posted by bruce2bowser

Ship Anchor Chain Mailbox Post (2025 Update)

I always dreamed to have a mailbox made of welded ship anchor chain. I finally was able to obtain a good length (like 1...
4 comments posted 7yrs
posted by ignoramus21537
4 comments posted 7yrs posted by ignoramus21537