Hi Tony, So seeing as this motor will only ever be used on the TAIG I could get away with shortening the shaft on it and fitting a headstock pulley, at present the motor shaft is a good 4'' long so I could always wop a lump off it, should have remembered about the 5/8'' bore on the headstock pulley from when I assembled it,
many thanks gentlemen, Terry
The message from Steve Blackmore contains these words:
The TAIG motor pulley is presently 1/2'' but i cant bore it out to
5/8'' without losing the smallest pulley diameter, what I need is a pair of replacement pulleys one at 5/8'' and one at 1/2'' so i can use the motor with the 5/8'' shaft, it is a high quality GEC motor, brand new and unused running at 2850 rpm so would be perfect for my needs,regards, Terry
Ahh - Peter supplied me two 5/8th's pulleys, may have been in error but worked out fine ;)
-- Steve Blackmore
Have something to add? Share your thoughts — no account required.
Ask the community — no account required