I'm on the lookout for a QC30 toolholder that can hold cutter shanks of
25mm/1", if they are available. ( this is to hold a specially ground 15 deg dovetail style cutter ) Bob- posted
16 years ago
I'm on the lookout for a QC30 toolholder that can hold cutter shanks of
25mm/1", if they are available. ( this is to hold a specially ground 15 deg dovetail style cutter ) Bob
search ebay with the word deadlock chuck
no 30int ones on there are the moment though
all the best.mark
I've got an endmill holder spare in 25mm/QC30, new unused (found a set of tooling after buying this, so never used it)
Take the obvious spamtrap out of my return address
Tim
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.