Having carefully installed new Oilite bushes in the apron of my Myford ML7 lathe, I belatedly wonder if I should have impregnated them with oil first. Am I worrying unnecessarily? Will oil soak into them by capillary action?
Cliff Coggin
Having carefully installed new Oilite bushes in the apron of my Myford ML7 lathe, I belatedly wonder if I should have impregnated them with oil first. Am I worrying unnecessarily? Will oil soak into them by capillary action?
Cliff Coggin
Yes
--
Chris Edwards (in deepest Dorset) "....there *must* be an easier way!"
From the state of the shaft on one that had been fitted by a previous owner, I would do what I did when replacing shaft and bushing. Which is to drill a small hole through the bushing to allow the oil directly onto the shaft.
Mark Rand RTFM
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.