training DVD


I am thinking about starting to do model engineering, I went to college in

1966 and had some training on lathes. I seem to have forgot all they taught me so I was going to purchase a DVD. I wondered if any one had seen the DVD either the Rudy Kouhoupt one or the one from Chronos, and what there thoughts were on them.
Reply to
Harry Wheeldon
Loading thread data ...

Go here lots of info and small vids to download free

formatting link

and here larger videos to download that teach you the bacics again free

formatting link
all the best.mark

Reply to

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.