⚙ Model Engineering in the UK

  1. Home
  2. ⚙ Model Engineering in the UK
6651 Threads Posts
to

Worth reading in ⚙ Model Engineering in the UK

FA: Assorted hydraulic components, oil coolers, pump

Listing a bunch of hydraulic hoses, pipes, a hydraulic pump with mains motor, filter, valve, 2 oil coolers on ebay. Too...
0 comments posted 21yrs
posted by aholeintheground
0 comments posted 21yrs posted by aholeintheground

Stopping Rust in the workshop?

Having moved house about 2 months ago, the brick garage with a flat roof looked like being an improvement on the 10 x 8...
36 comments posted 21yrs
posted by paul.swindell
36 comments posted 21yrs posted by paul.swindell

Milling machine

I am looking to purchase a Milling machine in the new Year Sub £1000 . I cannot fit a bridgeport and the likes into my...
9 comments posted 21yrs
posted by ivanp.1i4zca
9 comments posted 21yrs posted by ivanp.1i4zca

Anyone been to Sandown Park?

Having been sorely disappointed on my last two visits (slow learner, see), I swore off it this year. Anyone been? Has it...
7 comments posted 21yrs
posted by nigele
7 comments posted 21yrs posted by nigele

Bench Drill Vice - help!

I have just bought a new bench drill and am now looking for a vice for it. It appears that a 3" vice is the size that w...
3 comments posted 21yrs
posted by mg
3 comments posted 21yrs posted by mg

Sash Weights as a source of cast iron bar

Typically, what sort of quality will the cast iron be in discarded sash window weights? Steve
7 comments posted 21yrs
posted by steve.withnell
7 comments posted 21yrs posted by steve.withnell

Flat Belts

Had a slight disaster over the holidays when the flat belt drive on my 9" Southbend finally gave up the ghost (it has l...
7 comments posted 21yrs
posted by kevin.newsgroups
7 comments posted 21yrs posted by kevin.newsgroups

Dickson S1/T1 Toolholders

Before I venture out and buy some new ones I don't suppose that anyone has any T1 sized Dickson quickchange toolholders...
0 comments posted 21yrs
posted by Wells_hall
0 comments posted 21yrs posted by Wells_hall

Oiling Slip Gauges

Does anyone know the best type of oil to clean and protect slip gauges when putting them away after use? Regards Steve L...
2 comments posted 21yrs
posted by steve
2 comments posted 21yrs posted by steve

Camtronics 2 amp board

Hi I am testing my Camtronics 2 amp board and have downloaded the desknc proram to complete setup of board. I am having...
0 comments posted 21yrs
posted by anthony
0 comments posted 21yrs posted by anthony

It's all over

Now it's all over and done with, Christmas and all that xxxx I mean, The turkey's been eaten, the puddings all gone, on...
0 comments posted 21yrs
posted by alan_marshallthomas
0 comments posted 21yrs posted by alan_marshallthomas

Greetings!

Compliments of the Season to all the splendid people on this NG May your swarf grow in constant profusion, And your too...
1 comments posted 21yrs
posted by mike
1 comments posted 21yrs posted by mike