Hi,
Can anyone tell me where I set the size of the BOM balloons in the EMX (Expert Moldbase eXtension)?
Right now the balloons are really big, I think 25mm diameter, and it don't look good on a drawing. I want to set them just a little bigger than the text in them, and the text should not be higher than 5mm, maybe 7mm.
The 'support' that costs $3750 a year don't seem to know, because I don't get an answer.
regards Bjorn
If you want to apply a range limit to BOM Balloon size, use the detail setup options (File > Properties > Drawing Options)
min_balloon_radius
max_balloon_radius
Set a numeric value for each. the values apply to all newly created balloons. If you set a value of zero there is no min. or max. radius.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.