1. Home
  2. PRO/Engineer (Creo) discussions
  3. import problem in sketch

import problem in sketch

The actual problem is when i am importing the snappble point itself
is
taking as geometric centre of the drawing, in autocad when we copy it
will ask base point. I am looking for similar option in Pro/e is it
possible. Is there any other way
Reply to
ramu
Loading thread data ...

Site Timeline

Related

  • Problem in Importing sketch

  • The actual problem is when i am importing the snappble point itself istaking as...

  • Sketch problem

  • I get the following message: Sketch9: Warning: This sketch contains dimensions...

  • Snapping point problem in sketcher

  • I am drawing a rectangle and saving as abc.sec, then i am opening anew file in...

  • problem importing iges file

  • hi,I have an iges file simply a hollow cylinder(with outter radius say 5mmand...

  • SKETCH TOOL PROBLEM

  • Hi all,I had a hard time using the function "Linear Sketch Step and Repeat"which...

  • problem importing DWG with polylines

  • I am starting to use Solidworks 2005. (I've been through the 2004tutoral,...

  • NthreadsP problem

  • I'm trying to use the NthreadsP program to generate gear trains for oddball...

  • Bridgeport problem

  • I moved my Bridgeport to my new shop a couple months back. The new shop hadto...

  • Problem interface export/import

  • I've got a big problem to export with wilfireWhen i would export the sytem...

  • ABAQUS Problem

  • I am trying to assign the geometric coordinates to nodes in ABAQUSusing...

  • Econotig problem

  • Welding some 20ga 304 stainless with my Miller Econotig. Since it's too thin...

  • AMPOWEREDIT problem

  • I have lost the special characters in AMPOWEREDIT, all I get is a pile ofjumbled...

  • Hardinge HC problem

  • I brought that Hardinge HC home (the one that I advertised here) andwhile it...

  • Assembly Sketch Relation problem...

  • Hi All. I am using most current version SW(2007 SP4). Here is mytrouble:I am...

  • Table feed problem?

  • I have an old Enco 135 table feed (Model # 205-6215) on my mill, which has been...

  • Bridgeport DRO problem

  • A manual Bridgeport with standard DRO fitted has a problem on the X axis...

  • power hammer problem

  • i have a electrically operated power hammer.it works on fast and loosepully...

  • problem with grapes

  • Hi Larry. Thanks, I did not think of a cold chisel. That should dothe trick. ...

  • Airbrush Moisture Problem

  • Revell Gamma compressor; aztec airbrush; moisture trap and filter; lifecolour...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.