Rounding in Note

Feb 18, 2008 1 Replies

Rate this thread:

Aggrevated 18 years ago

Ok. So i have two parameters:

&Over_Shaft = .4649 &Over_Shaft_Tol = .0005

I'm inserting a note into my part by doing a "insert annotation feature"->"add"->"note" and type something like:

&Over_Shaft &Over_Shaft_Tol

but. What appears on my screen is:

.465 .001

How do I force Pro/e to use 4 place in a note?

Thanks!

Vote

mdR 18 years ago

~should~ be &over_shaft[.4] config settings leading and trailing zeros may have an effect on this though. ::mark

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Ask the community — no account required