Yes, the point is to support the igniter and prevent it from dropping down.
Just think enough to support the igniter. Pretty thin.
Yes, the point is to support the igniter and prevent it from dropping down.
Just think enough to support the igniter. Pretty thin.
1/16" works great (since 1972 :).
It is ejected during the ignition ramp-up, typically within the first
14ms.The reason to use a thin dowel is so the Kni is not very substantially modified thus preventing overpressure on any reasonable motor design.
Just techin'
Jerry
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.