Xp Pro SP2 Sw office pro 2006 sp0.0
Help wanted please!
I have a main assembly that was built in SW Office Pro 2005 sp4.1 In this assembly is a sub-assembly which has just one sheet metal part. Whenever I rebuild the main assembly this sheet metal part, (not the drawing for this part), shows that a change has taken place in this part document. When I open the drawing for this part it needs to be saved due to a change in the part.
I then made another sheet metal pat in sw2006, added this to the sub assembly and this part also changes when I rebuild the main assembly. Both of these parts are simple plates with notches, 1 flange and 3 mates to a frame. There are no configurations in any part and/or the sub-assembly that are in the main assembly. All drawings are 1 part 1 drawing.
This may be related, but on checking in any assembly everything gets checked in, but all of the part drawings show that they have changed and I have to check these in again individually.
Thanks!