Help!! extrude-cut on Lofted Bend

I am designing a plow for a locomotive. Similar geometry to a snow plow on a truck. I need to make a cut out for an access door on the bend of the upper portion of the plow. I have tried a few things- (unfold, cut, and then try to fold) gets an error saying some features cannot be folded. I would like to make the cut on the flat pattern(layout). Any advice?

Thanks, Eric

Reply to
ericschwiet
Loading thread data ...

I figured it out.....I had an extruded-cut through the lofted bend in the folded state. Since that cut was there it gave an error for a cut in the unfolded state.

Reply to
ericschwiet

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.