I hope anyone can help me out regards HP DesignJet problem. It seems that SW cannot print out on A1, A2 cutting paper with full fit drowing. But since HP Designjet 430 was the one of the most reasonable tools, not a few users must be working with the plotter, i guess.
I think we had a c450 and I always had problems with it. Recently I finally figured out what the problem was. It defaulted to a 36"roll in the driver so when you set it to auto rotate to save paper it would rotate it sideways and cut half of the print off. So make sure your roll setting is identical to your actual roll and that auto-rotate is on. I don't know if this really has anything to do with your issue or not.
regards, Corey
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.