Hi,
I came across a problem when plotting. We have changed to Wildfire some time ago and I just copied the .pcf files and plotting mapkeys from our 2001 setup. It worked without any problem until recently when I had to plot an A0. With 2001 the plotter rotated the paper (roll) correctly to use minimum amount of paper. A1 was plotted as landscape, A0 as portrait with the same settings. With Wildfire the A0 plots as landscape and gets clipped so about 30% is missing.
ProE 2001 release 2003090 ProE Wildfire release 2003170 Plotter is an A0 SELEX SR-850E (HP-GL/2 + RTL) Plotter drivers tested DESIGNJET, DESIGNJET600, DESIGNJET750C. Same result, plotting A0 works in
2001 not Wildfire.It seems like the driver has been changed and maybe it sends some command to the plotter which stops the plotter from manipulating the drawing data.
Any ideas on how to fix this?
regards Bjorn