Is it possible to link the area of a flat pattern (sheetmetal) part to a drawing field?

I know that if you click on a flat pattern face and use the measure tool, this will give you the square area of that part. Is it possible to link this to a field on a drawing?

Also, if anyone has a macro that will give the square area of a part in feet, please post. Currently, I have to change the units from inches to feet whenever I need the area of a part.

Reply to
SW Monkey
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.