Is it possible to join two splines into one if they share an endpoint ?
I imported an adobe illustrator and it seams like all the splines have
32 handles. I would like to join them and the simplify them.I am in the process of migrating to SW2007SP1.0 regards Giorgis
Dear Giorgis,
I did this once using FIT SPLINE command and that worked for me in SW
2006 sp 4.0. I feel you can try that one.You can find this comand in "Tools>Spline Tools>Fit Spline"
Regards
Deepak Gupta
Giorgis wrote:
I discovered it my self half an hour ago, but you are spot on. Fit spline is a great tool. I actualy used it to trim offset splines as well. You are not allowed to do that, so I tack on a line at the end of an offset spline. I fit a tight spline (delete the base) and trim away.
It great, thanks Deepak
GPS: I now have SW2007SP1.0
Eng> Dear Giorgis,
Dear Giorgis,
Thx for the info that things worked for you.
Regards
Deepak Gupta Giorgis wrote:
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.