I was using MoldFlowExpress to check a few plastic parts the other day. Now I went back today to use it on another part, and it's gone from the pull down menu. I did find a toolbar button for it in the group of 'Mold Tools' buttons, but it's always greyed out.
Anybody else have this problem and how did you get it back?
Richard
Hello Richard-
I sent you an e-mail because I included an attachment(no attachments allowed here).
Let me know if you don't receive it.
Best Regards, Devon T. Sowell
Have you installed any service packs recently? I had a similar problem that screwed up my registry, and the drafting environment was greyed out.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.