When you choose shadows in shaded mode for the view is there any way to change the location i.e. distance form the model and orientation i.e. I want it to cast on the right plane orientation not the top plane, the virtural ground the shadow is cast on?
Ben
Just turn the model 90dgress, with right side pointing downwards and then turn on shadows, now flip it back and the shadow will follow and stay till You turn it off/on again
Krister L
"Ben" skrev i meddelandet news:4%Y%d.101882$gJ3.62160@clgrps13...
Thank you, now how do I adjust the distance of the shadow from the object?
Ben
I'm sorry, but I have no good answer to that one....never tried to change it and actually not using the shadow mode very often either.
Krister L
"Ben" skrev i meddelandet news:4o%%d.102962$gJ3.94097@clgrps13...
I havent used it in the past but could make some quick screen captures for clients that way and have a whizzy shadow to boot if the shadow was not 3 miles away. Again not that important but thanks for the help
Ben
I think if you place a very small part several units "under" your existing part/assy the shadow will be generated from the "lowest" part. This would only be useful in limited circumstances though...
.01875¢ Whit
Ben wrote:
Have something to add? Share your thoughts — no account required.
Ask the community — no account required