I just got this in an e-mail today from SigmaTEK. I don't know how many other people use SigmaNEST for creating laser files, but we use it daily. I guess I'm going to have to wait a little longer now to start using SW2006.
Good morning & afternoon,
SigmaTEK would like to take a moment to provide some information to our current SolidWorks users. As is commonly known, SolidWorks has recently released version 2006. At this time the SolidWorks interface to SigmaNEST does not support this new 2006 version due to a problem within SolidWorks. SolidWorks is aware of the problem and it will be fixed in the 2006 Service Pack 2. Therefore, we recommend that this SolidWorks version not be installed until SolidWorks 2006 Service Pack 2 is released in mid-November. This release will include a patch to fix SigmaNEST-SolidWorks 2006 issue. Additionally, the latest production release of SigmaNEST version 7.0 will be required at that time.
Should you have any questions in regards to this matter, or you have already began using SolidWorks 2006 and are experiencing problems, please contact Technical Support at snipped-for-privacy@sigmanest.com.
We thank you for your patience and cooperation in this matter.
Sincerely,
SigmaTEK Technical Support