I am wondering if anybody has the source file used in the demo and if not if they could explain a bit how the set of curves at the end of the handle were connected so they moved proportionally.
Thanks.
Spoon boundary feature demo.
Mar 24, 2007
2 Replies
The SolidWorks Spoon Model is downloadable from Ricky Jordan's site:
formatting link
I believe your question, correct me if I wrong, is how did I make the end profile sketch of the handle move proportionally? The sketch is a series of splines that are constrained to construction geometry. The construction geometry is unconstrained to the point where I can adjust the spacing of the flutes. This is the beauty of construction geometry in SolidWorks.
Regards
Mark
That's exactly what I'm talking about. I'm hoping to be able to see exactly what the constraints were as I tried to duplicate it but it didn't move proportionally. Oh and thanks for making that BTW. It's amazing sometimes the amount of good information that can come out of one short, well-done, tutorial/demonstration.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required