Re: Little N gauge Mallet loco.

Thanks for the suggestion.

-- Jim McLaughlin

**************************************************************************** **************************************************************************** I am getting really tired of spam, so the reply address is munged. Please don't just hit the reply key. Remove the obvious from the address to reply. **************************************************************************** **************************************************************************** Special treat for spambots: snipped-for-privacy@ftc.gov, snipped-for-privacy@ftc.gov, snipped-for-privacy@ftc.gov

>William, I expect that you know who the Australian dealers are, but if you

> >have any ideas on who the US dealers might be, I'd appreciate it. > > BLW will be selling these >
formatting link
Bob Russell > Orange Belt Lines >
formatting link
Reply to
Jim McLaughlin
Loading thread data ...

has this been released yet? if not, ,what's the MSRP? I like these, and if they're 1:150 scale, that would be pretty close, not too widely off scale for operation on N scale layouts, if my mind is working right, remembering thigngs.. N scale would be 1:160..

Mike

Reply to
Mike Walsh, JR.

Ji >

formatting link
>

Mokei is the US distributor for Micro Ace. Phone number:1-314-725-8413 Ask for Lee. Mike

Reply to
Michael Usoff

Ahhh. I've previously bought Kato Japanese prototype C 58s from Lee at Mokei for HOn30 conversions.

Good service, fair prices.

Thanks for the tip on the importer.

-- Jim McLaughlin

**************************************************************************** **************************************************************************** I am getting really tired of spam, so the reply address is munged. Please don't just hit the reply key. Remove the obvious from the address to reply. **************************************************************************** **************************************************************************** Special treat for spambots: snipped-for-privacy@ftc.gov, snipped-for-privacy@ftc.gov, snipped-for-privacy@ftc.gov

Reply to
Jim McLaughlin

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.