Fly wheels

Any recommended method of fixing fly wheels to Mashima motors? Pending
advice to the contrary I was going to slip a smear of Loctite or Araldite to
the shaft and leave it at that. Cheers.
Reply to
Chris Wilson
Loading thread data ...
Loctite 601 or 603 will do nicely. Just one tip - fit the flywheel, then put a bead of Loctite on the shaft at the opposite end to the motor bearing, then twiddle the flywheel round the shaft so the Loctite runs in. If you put the Loctite on first, you run the risk of it entering the motor bearing.
Reply to
Paul Boyd
Cheers Paul, "that'll do nicely".
Reply to
Chris Wilson

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.