I am thinking of buying a Trailblazer for both stick welding and tig. The cost of wiring up my garage along with a tig power source is about what I would pay for a trailblazer. So my question is how does a trailblazer compare with a Dynasty 200 or Syncrowave 250 ?
Thanks for any advice on this.
It would be fine if you plan on TIG welding stuff 16 gauge and heavier, but you won't have anywhere close to the control on an inverter TIG.
I know guys who just plug a inverter TIG into their Trailblazer or Bobcat.
I do want to be able to tig thin metal, so it would be better to go with the cheaper Bobcat, which is about $1K less than the Trailblazer.
Do you have any recomendations for an inverter tig that could be powered from a Bobcat ? Thanks for the advice.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.