If a tig is stated as having a range of 20-200 amps will it butt-weld steal thinner than 20 guage..thats about 0.7mm....without blowing thru etc. This is a conventional ac-dc transformer tig with no slopes or square wave or pulse. all the best..mark
1 amp per thousandth for single pass welds.
0.001" = ~ 0.025 mm
so 0.7mm / 0.025 mm = 28 amps.
So yes it will weld metal that thin if you can dial it down far enough.
Ernie wrote
1 amp per thousandth for single pass welds.0.001" = ~ 0.025 mm
so 0.7mm / 0.025 mm = 28 amps.
So yes it will weld metal that thin if you can dial it down far enough.
********************************************* That's exactly the information i wanted. thankyou Ernie the welder will go down to 20 amps. therefore the welder will do all of what I ask of it,then. All the best...markPolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.