⚡ Welding Forums

  1. Home
  2. ⚡ Welding Forums
6253 Threads Posts
to

Worth reading in ⚡ Welding Forums

Gas Mixer question

Hi, Does anyone know where I could find a diagram / schematic / description etc. of the innards of a 2 gas proportional...
0 comments posted 20yrs
posted by 1313
0 comments posted 20yrs posted by 1313

Is that a voltage sensing wire feeder?

Could it be used with a CC welder like a hobart cybertig, to make it into a mig welder? http://cgi.ebay.com/ws/eBayISAPI...
1 comments posted 20yrs
posted by ignoramus14135
1 comments posted 20yrs posted by ignoramus14135

new at welding

Hi I would like to knowe where I can get a good used mig welder and what i should look for in a mig welder and info on p...
3 comments posted 20yrs
posted by saab9turbo
3 comments posted 20yrs posted by saab9turbo

H bridge cross conduction (TIG inverter)

Or relevance to sci.engr.joining.welding is a question of how much current "leak" would not trigger turn off of the hig...
0 comments posted 20yrs
posted by ignoramus28489
0 comments posted 20yrs posted by ignoramus28489

Question for RDF

Not saying that others here couldn't answer the question I just thought RDF Rob might have a little more experience for...
9 comments posted 20yrs
posted by buke9
9 comments posted 20yrs posted by buke9

truck hoist specs/diagrams?

i am trying to find some diagrams to follow to build a small dumpbox for my 3/4 ton i plan to use an electric motor to p...
2 comments posted 20yrs
posted by mr_mado2k2
2 comments posted 20yrs posted by mr_mado2k2

Victor torch tip part number meaning?

I picked up an older Victor 100 type handle with cutting torch attachment. It's a nice kit. It has 2 cutting torch tips...
8 comments posted 20yrs
posted by grant
8 comments posted 20yrs posted by grant

Increasing Welder Output Power

Gentlmen, I have a small 120V MIG Welder with a max. output of 87 Amps at 25V. with an O.C.V. of About 35V. If I instal...
6 comments posted 20yrs
posted by <taftave
6 comments posted 20yrs posted by <taftave

MIG - measure Volts, Amps, wire-feed-speed

Hello all Getting into MIG welding. However, my notebook full of arbitrary settings for different machines like "2-4,8"...
11 comments posted 20yrs
posted by r0d1s3
11 comments posted 20yrs posted by r0d1s3

Rig Welders Fab table ideas?

I am a rig welder of 24 yrs. I always used the deck of my truck to spin out pipe . I have been given a few contracts to...
0 comments posted 20yrs
posted by unknown
0 comments posted 20yrs posted by unknown