1. I've just bought a Sanwa RD8000 Super on and entered the service mode to change throttle from mode 1 to mode 2. Unfortunately I've used the service description from lover model (RD6000) which caused the RD8000 software halted. Now I can switch the sender ON, thent "TH Hi" message appeares on the screen, then prompt disappeares and no menu on the screen but battery state and model number in the left upper corner and active trim. Normaly, during normal operation, in the center of the screen the menu apperaes.
  2. Is therew any possibility to returnt to the factory settings of the sender? Is there any hardware reset switch or any key combination which resets the software? Can anyone help???

W.Fr±czek e-mail:

Reply to
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.