2008 MOVE issue

I've AutoCAD 2008... and I'm getting use to the ToolTip info at the
intersection of my Cross Hairs...
However, I've noticed an interesting problem.
In a Move Command... if I have a Selection Set of entities (lines, blocks,
what ever)... and pick an Origin point (screen selection)... and then I want
to TYPE in my 2nd point - 0,0 ... the Move command ends and the selection set
isn't Moved to 0,0.
It seems like I can enter the Base point by Typing in the X and Y...
Previously when I had all my Commands on the Command Line, naturally this
worked just fine.
Is there a Trick I have to use to type in the 2nd X and Y points now?
BruceF
Reply to
Mr. B
Loading thread data ...

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.