Yam CK2 problem

Jun 05, 2006 1 Replies

Rate this thread:

Eduardo 20 years ago

Hi all:

Recently we have buyed a YAM CK2 (Fanuc 6T) lathe in an auction, of course... no manual,no schematic,no anything...

The lathe work fine a couple of months, but today awake with an error.

The command panel is

formatting link

At power on the red light turn on, stopping all function. What mean this light?

Any help will be welcomed.

Best regards. Eduardo.

Vote

PrecisionMachinisT 20 years ago

Remove the RED bulb....

...LOL...

IF its an emergency fault interrupt, then simply trace the line--all switches /sensors are in a series configuration....

In the absence of any schematics, a good place to start is at the actual emerg stop switch--trace the circuit both ways from there.

Vote

Join the Discussion

Have something to add? Share your thoughts — no account required.

Ask the community — no account required