1. Home
  2. ⏚ Electrical Engineering
  3. New Offset Bend Calculator Online

New Offset Bend Calculator Online

I have completed a new offset bend calculator in JavaScript and placed it at my site

formatting link
under calculators. There is an extensive article describing how this calculator is programmed. This calculator does not use the Benfield Tables that are very inaccurate. I will guarantee that if you use this calculator correctly your pipe can be pre cut to length and bent to 1/16 of an inch of the desired height. For years I used the Benfield Tables to bend pipe and encountered problem after problem. My article that took about 150 hours of research is at
formatting link
make this post for the electricians that visit here.

Reply to
electrician
Loading thread data ...

Gerald Just to let you know, that the first picture does not show on the "offset" page. Dave F.

Reply to
David L. Foreman

That looks pretty decent, actually. Obviously a lot of work, and I like the included theory.

General, minor suggestion: Color code entry vs. calculated fields. I caught myself entering a value into a calculated field and it looked like it was goign to take it. I was interrupted and didn't get to go any furhter, but ... thought I'd mention it.

Pop

Reply to
Pop

I revised the article again. The figure you are referring to may be the FrontPage drawing now at the top of the second page which will not display in Netscape.

Reply to
electrician

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.