Does anyone have the specified distances for the hold-down bolts for a 9"x36 Horizontal motor driven lathe (e.g. 420-YN)? Please DO NOT go and measure your lathe. I can and have done that. What I want is the specification in the installation manual. Thank you.
9" SB bolt pattern
Aug 06, 2006
4 Replies
I've never seen an installation manual for that machine. If anyone would know it, you should check over at the practical machinist board, under the SB sub-heading. Ask for Paula. If she doesn't know, it can't be known.
Jim
What's the "practical machinist board?" URL? address? etc.
Boris
formatting link
Best Regards, Keith Marshall snipped-for-privacy@progressivelogic.com
"I'm not grown up enough to be so old!"
Boris
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required