the place I work for is pasturing a south bend lathe , 10x30 approximately, it ha spent the last 20 years since new as a collet lathe to make small bushing rods and what not
it is completely tooled, quick change aloris , steady , follow rests , chucks , 5c collet set up, really nice little machine , could use some work to tighten up the spindle bearings , if any one is interested I will post some pictures , otherwise I will probably clean it up and put it on ebay
It would be a great help if you could indicate where this machine is located, and an approximate asking price. If you did that, I doubt it would ever make it to ebay. Photos would be nice, as you suspected.
Jim
it is in Nashville , not really sure on price as I have not given the machine a good cleaning and inspection yet, want to make sure any buyer is fully informed
interested parties can email me personally and i will send pictures out over the weekend
Have something to add? Share your thoughts — no account required.
Ask the community — no account required