Any advise on obtaining or making a 4C collet to #4MT adapter?
Any advice on making a handwheel draw tube for said collet sice? Spindle bore is 1". 5C is for about an inch and a quarter spindle bore [oh, blast...].
You and me for 4C
Apr 07, 2006
2 Replies
I think I would start by buying a MT4 to MT2 or 3 spindle adaptor and having at that with some nice sharp carbide tooling. Should make for a straightforward job. A carbide drill to put an appropriate hole in, and a pressed in pin and the job's done.
If you wanted to get all fancy-schmancy you could thread the front end of the sleeve to fit a nut to remove it from the spindle with.
Cheers Trevor Jones
formatting link
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required