⏣ General Metalworking

  1. Home
  2. ⏣ General Metalworking
30777 Threads Posts
to

Worth reading in ⏣ General Metalworking

12voltDC ~ 5amp power supply

I made an exhaust vent system for over the the door of my wood boiler (when door is open any smoke gets vented outside)...
14 comments posted 19yrs
posted by mark
14 comments posted 19yrs posted by mark

silver and deming drills

I finally got around to sharpening my silver and deming drills. I have a cincinnati tool and cutter grinder and use har...
0 comments posted 19yrs
posted by jamodeo1
0 comments posted 19yrs posted by jamodeo1

Reasonable Price for Forklift Accessories

The previous owner of our property was a forklift expert, and an energetic and creative guy who liked to build interest...
2 comments posted 19yrs
posted by tim
2 comments posted 19yrs posted by tim

Trailer underside treatment

After I am done with my trailer, which could be as soon as tonight or tomorrow, I will need to paint it etc. For the vi...
22 comments posted 19yrs
posted by ignoramus5566
22 comments posted 19yrs posted by ignoramus5566

Roger Hull

I guess I might as well do this. The Worlds Greatest Impulse Buyer has bought it. He died around Oct. 2, 2006. I talked...
0 comments posted 19yrs
posted by mattsonsolar
0 comments posted 19yrs posted by mattsonsolar

Plastic 55 gallon barrels

I need two for my cabin to haul water. They must be clean, or be able to be flushed clean. Anyone have ideas where I mig...
32 comments posted 19yrs
posted by dsrttrvlr
32 comments posted 19yrs posted by dsrttrvlr

Looks like punched hole?

I have a chassis that I can't get my punch into and would like to get best looking hole I can by drilling. To the best...
7 comments posted 19yrs
posted by newszz10
7 comments posted 19yrs posted by newszz10

Scriber won't stay in combination square

The scriber won't stay in my Starret combination square. Is there any way to adjust the tension so it stops falling out?...
6 comments posted 19yrs
posted by devnull
6 comments posted 19yrs posted by devnull

round nose lathe bits?

the problem in a nutshell: I need to make several pipe bender dies/wheels with the wheels having a number of diameters...
33 comments posted 19yrs
posted by joelrf600r
33 comments posted 19yrs posted by joelrf600r

Drill press adaption

I have a drill press pedistal, table and 2-3/4" column that needs a head. I found this Clausing http://www.mckeanmachin...
1 comments posted 19yrs
posted by tom(nospam)
1 comments posted 19yrs posted by tom(nospam)

Retarding torque on shear back guage motor?

We have this old shear where I work and I've been attempting to do some long overdue maintenance on it. On the motor mo...
0 comments posted 19yrs
posted by clannorm
0 comments posted 19yrs posted by clannorm

Ground and used my first MoMax tool

I recently bought a Harbor Freight 6" double carbide grinder: . I then mounted a Norton aluminum oxide wheel on it. Thi...
44 comments posted 19yrs
posted by JoeGwinn
44 comments posted 19yrs posted by JoeGwinn

Need to punch a 1" Hex hole in 1/2" metal

I think one heats the metal and then uses a hammer punch to punch the hole. But where does one get the "Punch & Die? Any...
14 comments posted 19yrs
posted by rwatson767
14 comments posted 19yrs posted by rwatson767