⏣ General Metalworking

30777 Threads Posts
to

Millermatic 250

A local auction house will put it up on sale in a couple of weeks. I looked at the manual from millerwelds.com, and rea...
5 comments posted 21yrs
posted by ignoramus27036
5 comments posted 21yrs posted by ignoramus27036

air line through burried steel conduit?

Hi folks. I am hoping to run an air line from a compressor in my basement to my detached garage through a burried steel...
12 comments posted 21yrs
posted by ahall
12 comments posted 21yrs posted by ahall

Curved rack gear

Need a piece of rack gear, may be 5" long, curved to be a section of say 16" OD circle - so that the teeth are on the i...
11 comments posted 21yrs
posted by rashidk
11 comments posted 21yrs posted by rashidk

Bending AL diamond plate

If anyone has suggestions on how to achieve a smooth bend, I'm all ears. The plate is 1/8 inch thick, and the finished...
2 comments posted 21yrs
posted by tedbennett
2 comments posted 21yrs posted by tedbennett

Model engine magazine

I was so disappointed to see Strictly IC shut down. I have heard there is a new magazine coming out, called something li...
28 comments posted 21yrs
posted by stauffer
28 comments posted 21yrs posted by stauffer

Sandblasting our club logo on stainless?

We are giving stainless service trays to our top teams this year that we fabricated out of 304 stainless. Now we want t...
11 comments posted 21yrs
posted by vincent9993
11 comments posted 21yrs posted by vincent9993

Is it possible to tig pot metal?

The tailgate latch on my 94 Mazda/Ranger pickup broke today..so as an experiment, I tried to tig weld the broken parts,...
2 comments posted 21yrs
posted by gunner
2 comments posted 21yrs posted by gunner

Measuring Valve Guides

I want to check the valve guide bores in an automotive cylinder head. I've seen some small-bore micrometers that cost s...
9 comments posted 21yrs
posted by freeagent
9 comments posted 21yrs posted by freeagent

Casting supplies in New Mexico

I Have just relocated to Santa Fe NM and would like to know if there is a local source of Petrobond sand and other casti...
4 comments posted 21yrs
posted by bobo
4 comments posted 21yrs posted by bobo

Tips on looking for a fabricator

I have something that I would like fabricated. It's a food-grade stainless steel container that will need to withstand...
21 comments posted 21yrs
posted by derick.siddoway
21 comments posted 21yrs posted by derick.siddoway

Free Drawing master calcomp printer

I have a Calcomp printer, not sure if it works free to anyone willing to pick up in New Milford CT. Looks to be ok, If...
0 comments posted 21yrs
posted by wayneCLEARTHISTYPE
0 comments posted 21yrs posted by wayneCLEARTHISTYPE

Stainless Steel Welding with sp-135?

I own a Lincoln SP-135. I've read articles that say it doesn't produce enough amps to weld 14 gauge stainless. I've rea...
1 comments posted 21yrs
posted by joelholio
1 comments posted 21yrs posted by joelholio

Non-hazardous primer for aluminum

Need to paint the aluminum cover for a small enclosure intended for indoor use. I see zinc chromate and phosphate menti...
9 comments posted 21yrs
posted by oparr
9 comments posted 21yrs posted by oparr