⏣ General Metalworking

30778 Threads Posts
to

FA: Harig Grind-All #1

I have a Harig Grind-All No. 1 spin fixture on eBay for what I think is a pretty good deal. Reserve is $275 and I have...
0 comments posted 21yrs
posted by wallyblackburn
0 comments posted 21yrs posted by wallyblackburn

Resistance of different metals

Can anyone tell me the resistance values of different metal tubing? Like emt compared to copper,stainless,and aluminum?...
12 comments posted 21yrs
posted by stryped
12 comments posted 21yrs posted by stryped

metal wedges wotsit

Can anyone put a name to this? A tool dealer had 4 small metal wedges. Each was around 3" long, 1 1/4" wide, and tapere...
7 comments posted 21yrs
posted by bugbear
7 comments posted 21yrs posted by bugbear

OT (somewhat) Classifieds notification service?

I check 4 or 5 newspapers classifieds (online) in my area for used lathes. I am wondering if there is a service that wi...
0 comments posted 21yrs
posted by rex
0 comments posted 21yrs posted by rex

hydraulic cylinders

Is there a way to actually bleed the air from a hydraulic system which uses cylinders? If not does the trapped air in th...
2 comments posted 21yrs
posted by habbi
2 comments posted 21yrs posted by habbi

OT: Google 20 Year Usenet Timeline

Hi all, Found on Slashdot.com... interesting... http://www.google.com/googlegroups/archive_announce_20.html Erik
0 comments posted 21yrs
posted by erik
0 comments posted 21yrs posted by erik

Identifying a replacement light bulb

I have an indicator on my phase converter. Salvaged from somewhere. It is a 120 volt bulb, 3/4 inch diameter, and a dou...
9 comments posted 21yrs
posted by 3t3d
9 comments posted 21yrs posted by 3t3d

How can (multi-layer) sheet metal made?

I haven't had much luck in searching on how sheet metal can made. In particular I want to make small sample sheets with...
4 comments posted 21yrs
posted by doubleOh7
4 comments posted 21yrs posted by doubleOh7

safety photos

http://www.safetycenter.navy.mil/photo/archive/default.htm
0 comments posted 21yrs
posted by cmciver
0 comments posted 21yrs posted by cmciver

Is my old Delta Grinder Shaft Fixable?

I own an older Delta Grinder that I bought at a garage sale some time ago for $5.00. I can't find a model number, but t...
7 comments posted 21yrs
posted by lane (no spam) at copperaccent
7 comments posted 21yrs posted by lane (no spam) at copperaccent

Any advice Before I break something else?

onto the table> I have a couple of cheap drill chucks that feel like they've been lubed with a mix of rubber cement and...
9 comments posted 21yrs
posted by "spam "
9 comments posted 21yrs posted by "spam "

OT-Warning to men

Men are Victims too! Police today warned all men who frequent clubs and parties to stay cautious when offered drinks by...
15 comments posted 21yrs
posted by gunner
15 comments posted 21yrs posted by gunner

Home wiring and plugging in a welder

I would like to plug a 220V welder into my dryer outlet, since that is the only 220V outlet I have. But the house I'm r...
26 comments posted 21yrs
posted by no_spam
26 comments posted 21yrs posted by no_spam