Wanted: Simple machining (2 axial holes in round bar)
o 6cm-long round-bar o Axial 5mm hole 3cm-deep one end o Axial 11mm hole 3cm-deep other end
Usage: Slip 10mm (10.45mm) nylon rod in one end, drill into it with 4.4-4.6mm drill the other end. Vis., handheld-drill-press.
T304 would be nice, but plain steel is easier to drill.
Q: Anyone out there able to do such?
---- ideally I'd like 1 with 5mm hole, 1 with 3mm hole
Email snipped-for-privacy@ntlworld.com
Thanks.
-- Dorothy Bradbury
formatting link
for fans, books & other items
formatting link
(Direct)