Con due celle Li-Po si può usare un regolatore qualsiasi. Da tre celle invece ci vuole un regolatore con cut-off adatto alle Li-Po. Sul sito della Jeti è riportato quanto segue.....
ADVANCE SPEED CONTROLLERS FOR BRUSHLESS MOTORS Speed controllers for brushless motors are designed for best results with any type of motors and accumulators. - automatic cut off with auto detection of number and type of cells
- suitable for all types of accus NiCd, NiMh, Li-polymer
- safety cut off with Li-polymer accus (2,56V per cell)
.....poi però scaricando il manuale si legge.....
Cut off setting: · It is possible for the Master 04-3P, 08-3P and 18-3P to set cut off mode. · This part of setting is on the same place like frequency change (at Master 30-3P and more) o Cut off mode 1 ? (min. 4 V), ?long tone? ? NiCd/NiMh ( - , - , - , - ,
- ) o Cut off mode 2 ? (constant 5,3V), ?tone + beep? ? 2 Lithium cells ( - · , - · , - · , - · , - · ) o Cut off mode 3 ? (constant 7,95 V), two ?beeps? ? 3 Lithium cells ( · · , · · , · · , · · , · · ) · The speed controller will turn-off the motor when the main power pack voltage falls under 5V (4V for Master 04-3P, 08-3P, 18-3P and 30-3P in cut off mode 1) or reaches 0,7 V/cell. It depends on which occurs first. Soft Power Cut Off except you have controller with BEC and set-up brake on.
.......ma allora qual'è il regolatore che permette di programmare il cut-off? L'Advance o il Master? Boh!