1. Home
  2. Scale modeling discussions
  3. Need a couple of things

Need a couple of things

Does anyone have the RCR 1/72 Fat CR.42 detail set? I need a copy of
the instructions and the etched metal parts.
Also looking for an Airfix Vickers VC-10 and a Comet 4 from them.
TIA
tOM
Reply to
maiesm72
Loading thread data ...

Further Reading

  • 1/72 Italeri Fiat Cr. 42 Falco for sale

  • Anyone here interested in an Italeri Fiat Cr 42 Falco in 1/72? I won it in an...

  • Anyone need any Hardinge CHNC 1 manuals?

  • I have a good sized box of near new manuals for Hardinge CHNC 1 lathes if anyone...

  • Anyone need Hardinge 4C collets?

  • I?m looking for C4 collets if you still have a line on them. I need a set but...

  • anyone need a couple ?

  • To common,better if it was a 1/2 size extra 300 or the like ;)))

  • Riproduzione Fiat CR.42

  • Ciao,sto facendo una riproduzione di un Fiat CR.42 di circa un metro esettanta...

  • Does anyone have or use this ... Henrob 2000-welder

  • I was looking at this today. I am just getting starting in blacksmithing and...

  • CMK 1/72 TSR2 Exterior Detail Set

  • I received my copy of the above set in the post today and I have started...

  • need info on Galactica plastic model detail set

  • A company called Sub-level 3 produced a resin detail set for theModel of the...

  • Ahh need some fat tahrs

  • I'm looking for some fat tires. I have a JDF six-wheel armored vehicle...

  • Need a couple of Rareplane Items

  • Just received two Rareplanes items from a friend.The F-86H and Grumman Goose...

  • Anyone want an 00 gauge railway in need of restoration?

  • Hi folks, I have an 00 gauge electric model railway from the 1970s or '80s...

  • A couple of things

  • 2005 SP2I notice that if I am in sketch mode and make a move/copy or any edit...

  • Need oddball bolt: 1/2" x 12 TPI

  • Hi everyone -I've got a repair project on an ancient (pre 1900,...

  • Does anyone have the new Atlas N-scale Shay?

  • Have any of you tried out the new 2-truck Shay yet?It's only a matter of...

  • Re: Anyone need any Hardinge CHNC 1 manuals?

  • Just got home after a 12 week break... I run a CHNC with a refit control. If you...

  • Trade 1/48 Revell B-17F for 1/48 Monogram B-17 or B-24

  • I have an unbuilt Revell B-17F that I would like to trade for a 1/48 Monogram...
  • « previous thread

  • Dragon 1/35 T-34/85 question?

  • Any suggestions for detailing the inside of the turret/crew compartment of this...
  • next thread »

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.