2008 is screwed up!

I open a part. I double click a sketch. I change the view to bottom view
and then back to the front view. The sketch and the revolve from the
skectch are displaced.
Can anyone duplicate this?
Reply to
dlevy
Loading thread data ...
This is the same answer to your post earlier about revolve dimensions YES
Reply to
j
To be a little more accurate, '2008 is Beta, and some features aren't debugged.'
Reply to
Bo

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.