Hey all
I have a BOM customized so that it brings in surface area, the problem I am having with this is, if I use configurations the surface area figure should change but it only gives me the surface area of the default part.... anyone know the workaround? or is this possible?
Ben
you need to specify the config, use the following format; surface area@@config@model
Exellent thanks,
I also found that after I removed my head from my arse, that if I set a configuration specific value for surface area it finds itself to the BOM.
Ben
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.