Context selection

Sometimes when I open up SW, and without having any part, assy or drawing loaded, I have a greyed out flyout button in the place where the command manager usually are. If I move the cursor over this flyout button I can read "Context Selection". I can't find this in the customize menus or anything about it in the help files. When I load a part or anything the command manager turns up and this context button disappears. This is not happening every time I open SW ....most of the times it't not there ....but sometimes it is and I can't really put my finger on what makes it turn up. Anybody seen this and knows what it is?

Krister L

Reply to
Krister L
Loading thread data ...

some add-ins do not load icons until you are in a part/assembly/drawing.

Reply to
Sean Phillips

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.