Fat Fingers

I was editing a dimension and my finger hit between a couple of keys at the same time. Now when I go to edit any dimension in a sketch, (in a part) the calculator and equation dialogue boxes pop up automatically.... quite frustrating. In additionI am now not able to change the value of some dimensions, especially if it is a degree?

Any ideas how to "turn off" this automatic feature?

I tried to close down SW without saving, and to open a different part but no such luck. Apparently, I was able to turn some "mode" on.

Thanks.

Reply to
Ed
Loading thread data ...

Ed..... Check to see if your "num-lock" is turned on... If it is off, and you try to edit a dimension your equations box pops-up... Hope that helps...

Jeff

Reply to
Jeff

PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.