I need help with cut lists in weldments! When I insert the cut list in the drawing,
I don't get the right qty's with certain items from the cut list.
I have made one item, and made a pattern, therefore it doesn't correct the qty.
Anyone know how to fix this?
Thanks
2 things to check in the part file: 1-If the cut list is automatic, did you right click the cut list folder and update it? and 2-If the cut list is manual, did you drag the new bodies into the existing cut-list-item folder?
When you did the pattern, was "Merge" unchecked?
Ken
You should also note, that the weldment BOM always reflects the state of "As Welded" configuration. Sometimes it may happen that there is different amount of bodies in different configurations. Make sure that all required features are unsuppressed in the "As Welded" configuration.
-h-
Also check the Geometry pattern/ use solidbody for pattern instead of selecting features. Al mentioned earlier, keep the bodies seperate.
-G- Heikki Leivo wrote:
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.