I am Inserting a hole callout and I want to put the bolt circle dia in the call out so that if the B.C. dia changes it will change in the hole callout. Is this possible?
Thanks
Nathan
I am Inserting a hole callout and I want to put the bolt circle dia in the call out so that if the B.C. dia changes it will change in the hole callout. Is this possible?
Thanks
Nathan
You will have to abandon the hole callout and create the whole thing from scratch using a note. Place the note, then double-click on the required dimensions to link them into the note.
You could keep the hole callout, and create the BC callout as a note, then just place the note next to the hole callout.
This may be considered bass ackwards but what we do is:
In our never ending quest for optimal model/drawing associativity, we also are using this method for sheet metal bend angles, slot dimensions and material thicknesses for the material callout in our title blocks.
Interesting. I had fooled around with building notes in the model, but I had always left them there and imported them into the drawing views. Your way sounds much cleaner. Except the part about showing all the model dimensions.
"Nathan Feculak" wrote in news:b5kKb.174428$ss5.146067@clgrps13:
Right.
PolyTech Forum website is not affiliated with any of the manufacturers or service providers discussed here. All logos and trade names are the property of their respective owners.