Does anyone have a macro to share that will put a plane half way between two selected parallel planes or surfaces? If not, is this possible with macros?
Macro for planes
Sep 28, 2005
1 Replies
I have no macro but if you hold down the CTRL key & drag any existing plane it will copy & default to offset distance place. but then you just change it to paralell at a point & choose the midpoint
There is also the midsurface command that will create a surface at the middle between two selected faces. if the surfaces are flat this would be just like createing a plane.
Hope that helps Steve T.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required