Pattern Extrude

- D
- Dames
  
  Contact options for registered users
posted
17 years ago

Wed, Dec 22, 2004 5:46 AM

Is it possible to oattern an Extude in a part EG: If you had a 200 x
200mm Extude with a thickness of 1mm and the extrude was 5000mm long
and you had you wanted to cut the Extude into 5 seperate solid. Can you
place a cut across 1 face then pattern that cut 5 times.

Loading thread data ...

- M
- McBrian
  
  Contact options for registered users
posted
17 years ago

Wed, Dec 22, 2004 12:32 PM

No but you can pattern the cut extrude sketch 4 times. When you do the cut extrude SW will prompt you which bodies to keep (selected or all). The sketch pattern can be edited later is desired.

Pattern Extrude

Further Reading

Is it possible to turn a linear pattern to a table-driven pattern?

Multi-extrude in one part

Linear Pattern Problem

How to create a staggered pattern feature in SW?

assembly to part.. possible ?

Self test to see if you suck at machining...

Is it possible to link the area of a flat pattern (sheetmetal) part to a drawing field?

Model Railroading: If you had it to do over..

Instant 3d - Extrude to Cut extrude ?

Possible to check if an add-in is enabled using API ?

how to tell if cutting board is Delrin ?

Is it possible to insert a sketch create in an assembly to a part environment?

Equation reference to another part in an assembly possible

Pattern a part question

Get sketch "out" of Extrude feature

SW BlueBeam Install

library feature - top down