I am trying to make an extruded cut of a rectangular profile into the side of an elliptical solid. I want the cut to go into the side of the solid exactly 2mm. In previous SW versions I was using offset from surface but for some reason I am coming up empty with this one. Any ideas appreciated.
SW04 Extruded Cut question
Dec 03, 2003
2 Replies
"IDAssociates Inc." wrote in news:Qjszb.57898$m24.50522@fed1read02:
your sketch sould be outside of the solid, use the offset from surface / reverse offset command. also make sure that the cut is pointing toward the solid.
Got it. Thanks. It is somehow more logical to specify the surface and request 2 mm lets say off that surface rather than a reversed surface and go " backwards " Thanks.
Join the Discussion
Have something to add? Share your thoughts — no account required.
Didn't find your answer?
Ask the community — no account required